Driving Test Tell Me Questions
Answer:
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side
Answer:
Find the information in the manufacturer’s guide, B post or fuel cap, use a reliable pressure gauge, check and adjust pressures when tyres are cold, remember to check spare tyre to refit valve caps.
Answer:
The head restraint should be adjusted so the top of the head restraint is as high as the top of your head, and as close to the back of the head as is comfortable. Note: Some restraints might not be adjustable.
Answer:
There should be at least 1.6mm of tread depth across the central three-quarters of the tyre’s tread around the entire outer circumference of the tyre. There should be no cuts or bulges in the side wall.
Answer:
Explain you would turn the lights on and then walk round vehicle (as this is a ‘tell me’ question, you don’t need to physically check the lights).
Answer:
The ABS warning light should illuminate if there is a fault with the anti-lock braking system.
Answer:
Explain how you would operate the hazard light switch (turn on ignition if necessary), and then walk round vehicle (as this is a ‘tell me’ question, you don’t need to physically check the lights).
Answer:
Explain how you would operate the brake pedal, make use of reflections in windows or doors, or ask someone to help.
Answer:
If the steering becomes heavy the power assisted-steering may not be working properly. Before starting a journey, 2 simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Answer:
Explain that you would turn on the fog light(s) (turn on dipped headlights and ignition if necessary). Check warning light is on. Fog lights should be used when visibility is less than 100m due to rain, fog or spray.
Answer:
Explain that you would turn on the dipped headlights and then the main beam lights, identify the main beam warning light.
Answer:
Identify the dipstick, state that you would remove the dipstick, clean it before reinserting it and checking the level describe check of oil level against the minimum and maximum markers.
Answer:
Identify high and low level markings on coolant tank or radiator filler cap. State that when the engine is cold you would remove the lid and how to top up to correct level if required.
Answer:
Identify reservoir, check level against high and low markings.